Professional Stainless Steel Pipe Manufacturer: The pursuit of quality, Excellence, Best meet customer needs.

Duplex 2205 Pipe

by:HHGG     2020-09-25

Ferralium® 255 – SD50 is a stainless steel which is provided in the sizzling labored and annealed condition. It achieves larger strengths than most different stainless steels and various corrosion resistant alloys, offering the potential to cut back part size and therefore weight and value. In Sanmac supplies, machinability has been improved without jeopardizing properties such as corrosion resistance and mechanical strength.


This is particularly related to crevices and tough floor end. The technical recommendation and proposals made on this Product Data Sheet shouldn't be relied or acted upon without conducting your personal further investigations, together with corrosion exposure exams the place wanted. Austral Wright Metals assumes no liability in connection with the information on this Product Data Sheet. Austral Wright Metals supplies a complete vary of stainless steels, copper alloys, nickel alloys and different high performance metals for difficult service circumstances. Our engineers and metallurgists shall be pleased to provide additional data and purposes recommendation.


316 is normally thought to be the standard “marine grade stainless-steel”, however it is not immune to warm sea water. In many marine environments 316 does exhibit surface corrosion, usually seen as brown staining.


The nature of duplex and tremendous duplex makes it a standard selection for the pipelines and pressure vessels within the petrochemical industry, in addition to pipework systems, such as risers and manifolds in the oil and fuel industry. Excellent weldability by all commonplace fusion methods, each with and with out filler metals. AS 1554.6 pre-qualifies welding of 316 with Grade 316 and 316L with Grade 316L rods or electrodes . Heavy welded sections in Grade 316 require publish-weld annealing for maximum corrosion resistance. Grade 316Ti may also be used as a substitute for 316 for heavy section welding.


The most typical drawback when welding duplex is not getting the heat enter and interpass temperatures proper. As talked about above, warmth has a dramatic effect on duplex, as a low heat enter or a high interpass temperature can disrupt the delicate balance between ferrite and austenite, and corrosion resistance and toughness are affected. The commonest problems throughout the HAZ are losses of toughness, post-weld cracking and decreased corrosion resistance. To avoid this, it’s essential that duplex welding procedures concentrate on limiting the amount of time at ‘red sizzling’ temperature, as an alternative of attempting to manage heat input over one move.

Custom message
Chat Online
Chat Online
Chat Online inputting...
Sign in with: